This phenomenon of avalanche like increase in electron hole pairs is called "avalanche breakdown". You need to know these "ten don'ts" for foreign trade personnel in electronic manufacturing services.
Use circuit diagram software to check the components on the circuit board for missing numbers and obtain resistance values such as "0", "00", and "~" on the physical object to ensure that the marked "is 00" on the physical object.
Remove the components and measure the insulation resistance between each output terminal to determine if there are any solder leaks or short circuits.

00, 015, 00, 020, 00, 100.
The H3C design kit adopts a semi bottom plate design, with LED light beads printed on the bottom plate kit. The cover of the LED light beads on the bottom plate is not set directly to the outline of the device, so the perspective is ultimately adjusted to the light beads.
F5C is equipped with three LED light strips, with band resistance devices and resistors. The power range is 12W-36W, and resistance loads that do not support external resistors are allowed and used. In order to limit the luminous power of LED beads, it is recommended to choose a resistance load with a resistance value of over 1W.
Please note that the work line of this product is installed on the LED flexible light strip, which can effectively prevent the LED flexible light strip from emitting abnormal high current when turned off. Just by turning on the green light, red light, and light bead at the bottom, the high current discharge can reduce the temperature rise inside the LED light strip with a power of up to 1mW. Therefore, due to the rapid increase in heat generated by the LED flexible light strip at the moment of opening, the LED flexible light strip becomes a high-density light strip, To ensure its bright output results.
In order to improve the technical requirements of LED flexible light strips and better display them, let's give you a specific explanation below.
LED flexible light strip refers to cutting the LED flexible light strip into copper foil or pre hard gold soft light strip circuit boards with a thickness of about 3mm to ensure its smoothness of illumination.
For LED soft light strips, they are then molded, so it is necessary to carry out LED light strip molding processing, and this process requires a certain amount of time. In the later stage, it is necessary to remove glue, waterproof, and prevent dripping.